Our 2018 16’ Expanda Outback with J-Tech suspension is not sitting square, when I look at the van from the rear it’s lopsided. When I crawled underneath I noticed that one of the rubber cone springs (inside the coil spring) has approx. 20mm clearance between the bottom of it and the bottom stop whilst the other side is touching i.e. no clearance at all.
It’s the driver’s side which is touching. The van is not loaded and is sitting on a concrete pad so I would think both rubber cones should have the same clearance.
Just wondering if anyone might have any ideas as to what might be happening?
It’s the driver’s side which is touching. The van is not loaded and is sitting on a concrete pad so I would think both rubber cones should have the same clearance.
Just wondering if anyone might have any ideas as to what might be happening?