Looking for where people are putting jerry can holders on the 14footers. Heading up north and want to carry spare diesel.
Cheers
Craig
Cheers
Craig
14' Series Jerry Can Holders
- Thread starter Craig and Leanne
- Start date
This is where it sat on my previous 14' expanda. Not an extended draw bar
Go to my Panda thread and you will see how I did mine, not only JC holders but shifted spare to rear of van.
Spare where it was was hard to get out with dual gas (have onsuite with HWS). Had to remove a gas bottle.
Also found spare retaining bolt got bent over when I went through large dip. Had to cut the bolt to get spare out.
Used old spare cradle as an annexe holder. I have the 2014 14.44-5 OB that does not have the front boot.
Hope it gives you some ideas.
http://expandasdownunder.com/threads/marv_marts-panda.5178/
Spare where it was was hard to get out with dual gas (have onsuite with HWS). Had to remove a gas bottle.
Also found spare retaining bolt got bent over when I went through large dip. Had to cut the bolt to get spare out.
Used old spare cradle as an annexe holder. I have the 2014 14.44-5 OB that does not have the front boot.
Hope it gives you some ideas.
http://expandasdownunder.com/threads/marv_marts-panda.5178/
Last edited:
Just a thought .....along the same lines.....we'd decided we didn't need Jerry can holders after we got the patrol with the extra tank but did investigate holders "just in case".
We found one advertised on flea bay which is still a possibility for us.....we have no spare space on front or rear of the van .....this one was a collapsible holder which was attached to the bar, travelled flat without interfering with the bed ends .....but broke down to an entirely flat unit when it wasn't needed....and the sides lifted up to brace the Jerry when it was needed.
I haven't looked for a while but it was listed as " collapsible Jerry can holder"
We found one advertised on flea bay which is still a possibility for us.....we have no spare space on front or rear of the van .....this one was a collapsible holder which was attached to the bar, travelled flat without interfering with the bed ends .....but broke down to an entirely flat unit when it wasn't needed....and the sides lifted up to brace the Jerry when it was needed.
I haven't looked for a while but it was listed as " collapsible Jerry can holder"