I have a 2013 20.63.1 and the LED clearance lights along the van are working but the ones at the top of the van on the front and back are not. Does anyone know if they need to be hooked up separately?
Thanks mate I will pull them out and throw a test light on them (and maybe tape the wires to the van before disconnecting them)Hey @Mick_309, don't be surprised if all the lights are buggered. I have the same can as you and one of my rears and the two fronts are stuffed on my van. I replaced the rear one no worries. But have now lost the wiring down the cavity on the front.
Given that I don't have any of them working they must not be connected. I can't imagine all 4 lights on a van under 2 years old would be faulty when all of the lower ones work. I had a bit of a poke around under the mud guard where the wiring harness comes out of the drawbar and there are 2 sets of terminals not connected. I will put 12v into them on the weekend and see what happens.
Thanks mate I will take that advice. Will you be able to re run your cable?No worries @Mick_309. The other thing I worked out is not to try and pull the wiring completely out, otherwise you may lose the connection in the wall cavity as I did today. If replacing just pull cable out enough that you can cut it and re crimp the new light on. Hope that makes sense.
G'day Col, Is that on the older models with the solid axle?not sure if these maybe the ones for the Stability thingy........
Not sure, going to have a look today, and see if I can dig them out.Thanks mate I will take that advice. Will you be able to re run your cable?