Picked up the new baby from Geelong Friday.Hand over went well until the hook up.We ordered the underslung version with recessed coupling as advsed by Jayco.When hooked up to Our Pajero SWB it was 70mm lower at rear than front,Paj was 70 mm lower at back wheels than front.Adding our Camec WDH made it worse.The Rep. who was doing handover said it was close to spec and would be fine without WDH.Driving home van felt twitchy compared to the avan We had just traded.I think I need a WDH but to achieve fitting one some sort of raising of coupling or lowering of towball tongue needs to happen.Ironically if the coupling had been fitted to top of aframe there would probably have been no problem.Will probably need to purcase a new WDH as the Camec is not suited to this type of chassis setup(will hit on chassis when turnig).Any thoughts of how to get around this problem?I will try to post some pics later.